Table of Contents

Section 21.1 from Matter and Interactions (4th edition)

Enclosed Charge

One of the coolest, yet strangest, features of Gauss's Law is that the electric flux through the imagined Gaussian surface is related to the total amount of charge inside the surface (the “enclosed charge”). For a point charge or multiple point charges, it is fairly easy to find the total amount of enclosed charge - you simply sum the amount of charge that is inside the surface you picked. However, if you have a line, sheet, or volume of charge, we need to rely on charge density to find the enclosed charge. These notes will review charge density and show how we find the enclosed charge for various shapes or distributions of charge.

Charge Density and Charge

We have talked about charge density in terms of finding a dQ, where we assumed a uniform (or constant) charge density. We will make that same assumption again here (the more complicated non-uniform charge densities may be covered in upper division courses). For a uniform charge distribution, the charge density tells you how much charge there is per unit length (for 1D lines of charge), per area (for 2D sheets of charge), or per volume (for 3D shapes of charge). For 1D charge distributions, we use λ as the charge density (which has units of C/m); for 2D charge distributions, we use σ as the charge distribution (which has units of C/m2); and for 3D charge distributions, we use ρ as the charge density (which has units of C/m3).

If we know the total charge and the total length/area/volume, we can calculate the charge density using: λ=QtotLtotσ=QtotAtotρ=QtotVtot

The charge density then can be used to figure out how much charge is in a certain amount of length, area, or volume, depending on what kind of charge you have: Q=λL=QtotLtotLQ=σA=QtotAtotAQ=ρV=QtotVtotV

As an example, say you have charged a 20 cm piece of tape so it has a charge density of λ=4.9107C/m. To find the amount of charge in the bottom 5 cm of tape, you would take: Q=λL

Q=4.9107C/m0.05m
Q=2.45108C

Or similarly, to find the total amount of charge in the piece of tape: Qtot=λLtot

Qtot=4.9107C/m0.2m
Qtot=9.8108C

We will use this method to find how much charge is enclosed by the Gaussian surface when solving for the electric field or electric flux.

Patterns of Electric Fields

For Gauss's Law to be easily solvable,