In the last few pages of notes, we have talked about how the surface charges are arranged to create a constant electric field in the wire. This electric field is responsible for pushing the electrons through the wire from one side of the battery to the other - creating a flow of electrons, which we called electron current. Building on this idea, these notes will go into how we mathematically define electron current and introduce what we call “conventional current.”

Before, we defined the electron current as the flow of electrons through the wire. We can make this more specific by defining electron current as the number of electrons passing through a point per second. Because the electron current is made up of negative charges, the electron current will always flow opposite to the electric field. (This is a more general rule that you may remember from before - electrons will always move opposite to the direction of the electric field.) We will use a lower-case “i” to represent the electron current: $$i=\frac{\# electrons}{second}$$

Since it is very difficult to actually count the number of electrons that pass a location, we generally write the electron current in terms of the electron density in the wire ($n$), the cross-sectional area of the wire ($A$), and the average speed of the electrons through the wire ($v_{avg}$). $$i=nAv_{avg}$$

Electron density is a property of the material, which represents the number of electrons per volume of the wire that are free to move. For example, copper has a high electron density ($8.4∗10^28 \frac{electrons}{m^3}$)

If we check the units of this equation we see that: $$\frac{\# electrons}{s}=\frac{\# electrons}{m^3}*m^2*\frac{m}{s}$$

Conventional current is then defined as the number of coulombs passing through a point per second. In this case, we can find this by multiplying the electron current by the magnitude of the charge of an electron. If the charge carriers aren't electrons (e.g., some kind of ion), then you will need to use the charge of the charge carrier. We will use an upper-case “I” to represent the conventional current. $$I=\frac{\# Coulombs}{second}=|q|i$$ The conventional current is now positive (number of electrons times the magnitude of the charge). By “convention”, the conventional current flows in the opposite direction of the electron current. In other words, the conventional current will flow in the same direction as the electric field. The units of conventional current are $\frac{Coulombs}{second}=\frac{C}{s}=A$, which we call an Ampere or an Amp for short.

For historical reasons, much of what we work with in circuits is based off of conventional current rather than the electron current (much of what we know was established before we discovered it was the electrons that were free to move; you can thank Ben Franklin for that). However, remember that physically, the electrons are what move in a circuit.