You are able to use your successfully MacGyver'd metal detector to track what the EM-boar tigers have left behind and find your trapped team members. But it is not only your team members you find. It is the EM-boar tigers base of operations. More important than rescuing your team members you observed something in their lair that effects the whole of humanity and needs to be communicated immediately. You estimate there is about 1 hour and 50 minutes to figure out a way to send some sort of E&M signal out for rescue before the EM-boar tigers realize that you are planning an escape. (What will that signal be??? You decide.) Due to the sensitivity that EM-boar tigers have to E&M waves, you only have one chance to send the signal before they realize what is happening and close in on the team. You will need to make sure that the attempt will work. You have a small metal ball that can be charged up 1e-6 C without discharging in air. You've found a piston that can shake the ball a total distance of 2cm, but at nearly any frequency you need. Your team decides to create a model of the signal to determine how best to orient the setup, how much charge to dump on the ball, and how quickly to shake it. Your group has already started setting up the code.

GlowScript 2.6 VPython

## Objects

charge = sphere(pos = vector(0,0,0), radius = 0.001)
charge.v = vector(0,0,0)

## Constants and model parameters

q = 1e-6
k = 9e9
mu = 4*pi*1e-7
mofpi = mu/(4*pi)

## Set up time parameters

t = 0
dt = 0.1


## Create list of arrows that encricle the charge
## Each location has two arrows: one for E and one for B

N = 20
theta = 0
dtheta = 2*pi/N
R = 0.02
ArrowList = []

while theta < 2*pi:
    
    Loc = vector(R*cos(theta), R*sin(theta), 0)
    
    ArrowList.append([arrow(pos=Loc, axis = vector(0,0,0), color=color.cyan),arrow(pos=Loc, axis = vector(0,0,0), color=color.magenta)])
    
    theta += dtheta

## Calculation loop

while t < 1000:
    
    rate(100)
    
    ## Charge should oscillate
    
    
    ## Loop through arrows to make E and B vectors
    
    for Arrow in ArrowList:
        
        r = Arrow[0].pos - charge.pos

        E = vector(0,0,0)
        B = vector(0,0,0)

        Arrow[0].axis = E
        Arrow[1].axis = B
       
    t = t + dt