Differences

This shows you the differences between two versions of the page.

--- course_planning:183_projects:project_template [2016/04/25 17:49] – [Project 1: Part X: Title] pwirving
+++ course_planning:183_projects:project_template [2016/04/25 17:50] (current) – pwirving
@@ Line 1: / Line 1: @@
 ~~NOTOC~~
-====== Project 1: Aspen Extreme - Part 1 ======
+====== Project 1: Part X: Title ======
-{{:snow-tubing-6.jpg}}
-Joe Bob runs a ski resort with the best ski hills in the area. The only thing he lacks is an awesome tubing hill with a tuber lodge at the top. Joe hires your group to design a hill with a mechanism to pull tubers from the back of the hill up to the top so people can slide down the other side and have lots of fun.
-Due to budget cuts, Joe Bob cannot produce enough snow to cover the entire hill. There is a 5 meter segment of dirt at the base of the hill. Keep in mind that in order to stay within safety regulations, the tubes should not go faster than 3 $m/s$ during any part of the lift. Joe needs to know the projected cost of the operation of your mechanism.
-====== Project 1: Aspen Extreme - Part 2 ======
-Once you are the top of hill, Joe wants the fun to begin. In order to keep up with the competition, the tubing hill needs to be exciting. There is a ramp at the bottom of the hill where the tubers will be launched through the air. A 5m diameter flaming hoop is located 15m from the ramp and 10m off the ground. Ensure the tubers complete this stunt through the hoop safely. Totally rad dude!!
 ====== Project 1: Part Y: Title ======
 <WRAP download 35%> Code for Project 1:  Part B\\ Keep them in the same directory.\\ {{:183_projects:|Project 1 Code (code.py)}}\\ {{:183_projects:physutil.py|PhysUtil Module}}</WRAP>